Use this page to identify each replacement part and follow the appropriate installation guide.
Before maintenance: Power off the robot before replacing brushes, filters or mop components. Compare the replacement part with the part removed from your robot before installation.
Pull the used dust bag upward by the handle and remove it.
Slide the new dust bag into the slot, unfold the bag, then close the cover.
Mop Pads
Round rotating mop pad installation video.
Quick Steps
Power off the robot and place it upside down on a clean, soft surface.
Remove both mop holders from the robot.
Peel the used mop pads off the holders.
Align the center holes and press the new pads evenly onto the holders.
Reinstall both mop holders and check that the pads sit flat.
Filter
Remove the robot dustbin and open the filter compartment.
Remove the used filter and clear loose dust from the surrounding area.
Insert the replacement filter in the same orientation and make sure it sits flat.
Reinstall the dustbin securely before use.
Side Brush
Power off the robot and place it upside down on a clean, soft surface.
Use the included screwdriver to remove the side-brush retaining screw.
Lift off the used side brush and place the replacement brush onto the mounting point.
Reinstall the screw securely. Do not overtighten.
Main Brush Pair
This kit contains 2 pairs of main brushes (4 brush pieces total).
Power off the robot and place it upside down on a clean, soft surface.
Open the main-brush cover and remove the installed brush pair.
Remove hair and debris from the brush compartment with the included cleaning hook.
Install one replacement brush pair in the same left/right orientation as the original parts.
Reinstall the brush cover and confirm it locks into place before use.
Maintenance Accessories
Maintenance Gloves
Wear the included gloves when handling dusty filters, used bags and debris-covered brushes.
Cleaning Hook
Use it to remove wrapped hair and debris from the brush area before installing replacement brushes.
Screwdriver
Use it for the side-brush retaining screw. Keep the screw for reuse.
Compatible Models
Designed as a compatible replacement maintenance kit for Roborock Qrevo S5V, Roborock Edge S5A and Roborock Curv S5X.
Compatibility note: Model names and regional versions can vary. Before installation, compare the shape and mounting points of each replacement part with the original part removed from your robot.
Need Help?
Email: support@vacbotca.com
Roborock is a trademark of its respective owner. This product is a compatible replacement accessory and is not affiliated with, endorsed by, or sponsored by Roborock.